Equipment Category: Refiners

Used 12″ Sprout Waldron R12EM Double Disk Refiner.

Includes Motor in rebuilt, excellent condition.

MAKE/MODEL: Beloit Jones 26″ Double Disk , Series 3000 Refiner
Very Good Condition
DD3000-26
30″ (750mm) Diameter Voith SDM-1 Double Disk Refiner
Fully Rebuilt to New Condition. New in 1999
Dual Voltage: 50-60Hz at 220V
Additional Performance Data:

Type – 1 SDM.
Ø disk – 30″ (750mm)
Max. Engine power – 600 kW.
Speed – 750-1000 rpm.
Motor Speeds: 50 Hz – 750 rpm., 60 Hz – 1800 rpm.
The concentration of mass – 3,5 – 6,0%.
Inlet pressure – 0,7 – 1,0 bar.
Overlooking max. pressure – 5,5 bar.
Productivity – 35 – 200 tons / day.
Control air – 4 – 5 bar.
Voltage Control – 220 V / 50 – 60 Hz.
The water pressure – at 1 bar greater than the maximum input pressure of mass.
Consumption of water – about 10 l / min. Machine weight (net) – 4.000 kg.00 kg.
Votih SDM-1 Double Disk Refiner

MAKE/MODEL: Beloit 30 inch DD400

DESCRIPTION: 30″ DD Series 4000 Beloit Walmsley Refiner
Two Each, Fully Rebuilt, Unused and in Excellent condition.

 

 

Voith SDM-1 30 Inch Refiner

MAKE/MODEL: 1999 Voith SDM Size 1 Refiner

DESCRIPTION: 30 ” Voith Model SDM Refiner, Rebuilt to ”NEW” Condition. Never Installed. Inlcudes New Controls
As New; cast Iron & steel construction with all wetted parts stainless steel.
Disc Diameter 750 mm (30”).
Throughput 35-200 BDMTPD
Stock Consistency 3.5 to 6.0%. / Max Motor Rating 600 kW (800 Hp).
Fitted with ‘no-flow’ safety device.
Variable gap width between Rotor & stators is both Manually & Motor
Operated via safety clutch arrangement (motor not supplied due to regional voltage variations).
New, unused Voith Remote control operating panel.
All operation, foundation drawings & electrical schematic manuals included.
Fitted with Pilao Tri disk re-conditioned Rotor & Stators.
Many new parts including main bearings, main shaft, gearbox housings etc.,

 

Rebuilt 34″ Pilao Tri-Disk Refiner, Model RTD-34
2 Each, Requires 350-600 HP Motors
RPM: 500-750 (@50Hz) / 514-720 (@60Hz)
Design Capacity: 65-600 TPD
Can use Beloit Refiner Plates
6% Stock Consistency @ 1-3 Bars of Inlet Pressure

Used R34 HA Sprout Waldron 34″ Diameter Dual-Refiner
Rebuilt with new hydraulics in 2006
350-950 kW at 500-750 RPM. Torque – 42.5 kg/m2.
Total Weight, including the dynamic load – 9130 kg.
Rated power – 700 kW at Synchronous speed – 600 rpm.
Refining Consistency of 3.6%